I believe you misunderstood the problem, the threads are not usually the problem, the problem is the brass heat insert the hinge threads into, the insert just breaks off the plastic with the screw still threaded in, usually because the hinge is a bit too tight/rigid and puts a lot of force into the insert pulling it out

this seems to be the case in this picture as well

seems like everyone is immediately suspecting HP, rightfully so… my HP also did this exact same thing and I had to epoxy it to the frame to get it back together

they do a good job cooling the place, the floors are cooled and there’s a lot of water sprayed everywhere and lots of fans and stuff, with the number of people going there there needs to be ample preparation.

they do a pretty decent job cooling the place, the problems are outside the kaaba area though, as they can’t cool down all the city,

the jordinians who died were sleeping in the desert as they were without permits and wanted to hide from the authorities.

the Egyptians though were not mentioned on any other news sites I know and I don’t see any references or sources, so I call bullshit.

I don’t see any references or sources at all in the page, and I couldn’t find other news sites with comparable numbers, I call bullshit.

it was reported that there was 41 jordanians who died trying to get to mecca without permits and they slept outside in the sun so that part was true but inflated number, the Egyptians thing is just a lie.

Stick*

It was the first distro I installed on my laptop and actually daily drived, it looks cool and the feels good to use

And since almost nobody around me uses linux it gives a very good image with how clean it looks